
To activate this option, open the window TFTP Server Settings and check Enable firewall support on General tab.Īfter the window is closed, TFTP server wil It is the standard port number for TFTP requests. However, this is not common for most of routers and firewalls.Īt the same time, WinAgents TFTP Server allows using UDP 69 port for files transmission. Cisco PIX Firewall) can identify TFTP sessions in data flood and dynamically change the table of addresses translation, allowing TFTP traffic through.

Therefore, even if you configured your firewall to redirect all UDP traffic with the port number equal to 69 to the TFTP server, NAT-device still will not allow TFTP sessions through.Ī number of devices (e.g. TFTP protocol supposes using random UDP ports to transfer files contents (Look at TFTP protocol part to get more additional information). WinAgents TFTP Server supports transmission of files via TFTP protocol through routers and firewalls, where NAT (Network Address Translation) mode is enabled. When you want to restore the backed-up IOS image from the server, you can use the copy tftp: flash: command.WinAgents TFTP Server Configure Server to Work through Firewall or NAT In this article, we have backed up the Router image to the TFTP server using Packet Tracer. You can watch the video below to back up the router image file and also subscribe to our YouTube channel to support us! When you check the TFTP server, you can see that R1’s IOS image has successfully transferred to the TFTP server. Then type the full name of the file you want to copy in the source filename (which file will be backed up) and then press Enter.Īs you can see in the image below, the IOS image has successfully copied to the TFTP server. To back up the router image to the TFTP server, use the copy flash: tftp: command.

Test the network connection by pinging from R1 to TFTP with the Add Simple PDU on the right panel of the Packet Tracer software.

The TFTP server Root folder is now completely clean. To enable TFTP service, select On and delete the files in it. R1(config)# ip address 192.168.10.1 255.255.255.0Ĭonfigure the TCP/IP settings of the FastEthernet interface of the TFTP server according to the IP block. R1(config)# interface gigabitethernet 0/0 First, open the Cisco Packet Tracer and create a network topology as follows.Ĭlick once on the Cisco Router R1 and in the window that opens, configure the GigabitEthernet0/0 interface according to the topology.
